Stepper motors

Hybrid Stepper Motors - NEMA 8 till NEMA 42

Hybrid stepper motors are a high precision positioning motion system. Their high power at relatively low speeds, and their ability work in full, half or micro step mean that a large majority of application problems can be solved by utilising this technology.
The hybrid motor technology can be considered as an optimal solution for a wide variety of applications today, with the absence of mechanical commutation and the use of high quality bearings enables these products to be considered where extended lifetime and or high loads (axial / radial) are needed or exist.
Available in 2 or 3 phases with sizes from NEMA 8 to NEMA 42 (20mm to 110 mm) and step angles of 0.9°, 1.8° and 3.6°. These hybrid products can achieve holding torques of between 1.6 mNm to 30 Nm, and are produced by Fulling motor, partowned by Delta Line, distributed by Lotax.

We can provide a high level of flexibility in terms of:

  • Output shaft modifications - Hollow shaft, keyway, length, etc
  • Wiring looms, cabling and connectors
  • Addition of pulleys, feedback devices etc
  • Customised windings
  • High axial / radial load capability
  • IP 65 rating (available upon request)
Certain versions are of a unique flat design that allow their use in space confined applications.

More about the offer on Delta Lines home page HERE:


Alla rättigheter © Lotax AB

Fyll i dina uppgifter och skicka så återkommer vi!

Fill out and send the form below and we will get back to you!

Formuläret innehåller fel. Kontrollera formuläret och försök igen. Tack! The form contains errors! Please check and try again, thanks!
Beskriv ditt ärende
Your message
* Obligatoriskt * Required

Tack för ditt meddelande!

Thanks for contacting us!